F E N CE S A N D G A T E S

Transcription

1 F E N CE S A N D G A T E S

2 The following Property Improvement Memo has been provided to assist Homeowners in preparing property improvement applications to the Association. It lists information which must appear on submitted applications. S a m p l e S i t e P l a n See Definitions for Site Plan. The Sample Site Plan below shows example of information needed, in green, for application of fences and gates. A p p l i c a t i o n R e q u i r e m e n t s : Completed Application Form Site Plan - Please, use site plan of your actual property provided by your Developer/Builder as basis for application. Site plans are within your paperwork a time of purchase. P l e a s e a d d t o t h e S i t e P l a n : Drawing of proposed location of new fence and gates Dimensions from front corners of your house to gate/ fence You may be required to provide additional information, including a professional survey, to meet specific requirements of the Property Improvement Committee. We urge you to not begin construction until you receive all of the appropriate approvals. APPROVED APPROVED DENIED

3 S a m p l e S i t e P l a n See Definitions for Site Plan. The Sample Site Plan below shows example of information needed, in green, for application of fences and gates. APPROVED C o n s t r u c t i o n R e q u i r e m e n t s : All fences must be installed within 6 months from approval of the application. Fences must comply with standard fence details, see Figures A and B. Fences must be stained according to Note 1 on standard fence detail, see Figures A and B. Fences must be set back from the front corner of the house by no less than seven feet on both sides. Fences must be made of wood. Fences allowed only along the rear property line bordering perimeter greenbelt: Black vinyl clad chain link 4ft only. Must attach to a 6 ft standard side fence. Stainless Steel Cable 4ft only Figure C. Must have a 4ft standard fence panel ( Fig. A and B, in 4ft ) attached to a standard 6 ft side fence ( Fig. A and B ), i.e. this fencing is to be sandwiched between two 4 ft standard fencing. See Fig C. Fences may not extend beyond property lines. Fences built on top of retaining walls must be built inside the property lines. On corner lots, fences must be set back from the street curb no less than ten feet, regardless of the property line location. Corner lot properties should follow restrictions for corner fences set by your local jurisdiction. Traffic and pedestrian sight lines must be maintained. Fences shorter than 6 m ay be allowed subject to PIC review and approval. You, the applicant, have the sole responsibility for ensuring full compliance with setbacks, easements, permits, fees, ordinances and restrictions associated with the modification of your property. Washington law requires you to Call Before You Dig, prior to any digging or excavation to protect you and underground utilities ( ) Approval by Property Improvement Committee does not constitute approval by any other jurisdiction, regulation or restriction.

4 F i g u r e A N o t e 1 : T h e f o l l o w i n g s t a i n s p e c - i f i c a t i o n m u s t b e u s e d o n a l l f e n c e s : Sherwin Williams Woodscapes, Special Mix RC156 (Redmond, WA Store) Semi-transparent, 2-coats S t a n d a r d F e n c e D e t a i l. N o t T o S c a l e

5 F i g u r e B N o t e 1 : T h e f o l l o w i n g s t a i n s p e c - i f i c a t i o n m u s t b e u s e d o n a l l f e n c e s : Sherwin Williams Woodscapes, Special Mix RC156 (Redmond, WA Store) Semi-transparent, 2-coats S t a n d a r d F e n c e D e t a i l. N o t T o S c a l e

6 This fence design is limited use only. It can be installed at the rear property line facing the perimeter greenbelt only. Stainless Steel Cable 4ft only Figure C. Must have a 4ft standard fence panel ( Fig. A and B, in 4ft ) attached to a standard 6 ft side fence ( Fig. A and B ), i.e. this fencing is to be sandwiched between two 4 ft standard fencing. See Fig C.